Skip to main content

Honeycomb

Starting Point for Setup of the AlphaStarting Point for Setup of the Alpha Configuration of the Alpha for a "Single Engine" MSFS C172Configuration of the Alpha for a "Single Engine" MSFS C172 Alpha and Bravo Config for the Aerosoft CRJ 550/700/900/1000Alpha and Bravo Config for the Aerosoft CRJ 550/700/900/1000 New Features and Capabilities for the Honeycomb BravoNew Features and Capabilities for the Honeycomb Bravo Setup All Axis, Switches and Annunciators for the SWS KodaikSetup All Axis, Switches and Annunciators for the SWS Kodaik Bravo / FBW A32NX Axis ConfigurationBravo / FBW A32NX Axis Configuration Alpha Setup - FSW C414AWAlpha Setup - FSW C414AW Bravo Config and Snippet for the PMDG 777 (MSFS)Bravo Config and Snippet for the PMDG 777 (MSFS) FFX/MG HJet Honeycomb Bravo ConfigurationFFX/MG HJet Honeycomb Bravo Configuration FFX/MG HJet Honeycomb Alpha ConfigurationFFX/MG HJet Honeycomb Alpha Configuration Re-Configure the Alpha Yoke to use the Default Configs!Re-Configure the Alpha Yoke to use the Default Configs!

This Video is a General Update to How the Bravo Layout and UI is handled in the Release version of SPAD.neXt v0.9.12!

There was a video update early in the Alpha phase but near the end of testing the final layout including sub tabs was introduced.

Honeycomb Bravo v0.9.12 Explained! New Config and New Layout!Honeycomb Bravo v0.9.12 Explained! New Config and New Layout!

Guide to the Bravo configured with the MS ATR 42/72-600. Includes the Download Snippet of the Configuration and the walk through of all of the controls. Note you must follow the steps to Calibrate and configure the ATR EFB. Look in the Chapters section.

HC Bravo and the MS ATR 600HC Bravo and the MS ATR 600

Big Changes with Axis GUI and Capabilities!! Much Desired Ability to bind Conditions with Axis is now here!! v0.9.13.39 is released and we can finally directly manipulate Axis mappings without the need for scripts!

Conditional Axis - Toggle Between FWD Thrust and REV ThrustConditional Axis - Toggle Between FWD Thrust and REV Thrust

Dash 7 Bravo Configuration. This includes setting up Custom Condition Lever Axis with Multiple Ranges and all Starter Switches required for successful Starts. Decision was made to go with 2 Axis For Throttles and 4 for the Prop/Condition Levers. AP and Annunciators fully functional.

Dash 7 Bravo Config Including SnippetDash 7 Bravo Config Including Snippet

How to Bind the TBM 930 Throttle in SPAD.neXt to have Control and Animation Working!!!

vJoy method is no longer needed. We can use B Events and K Events to tie it all together!!

https://youtu.be/4a9ZQ3aXV6Ihttps://youtu.be/4a9ZQ3aXV6I